electronoobz
- Jan 14, 2012
- 226
- Joined
- Jan 14, 2012
- Messages
- 226
as what you said, i can put the positive side on the source and the negative on the drain or reversed but when i look at the official site of the ruby amp i saw the perf board layout that the positive is soldered on the drain, but i didn't saw the negative side on where to put it.
omg! I still can't find 2n5457! Can i use 2n5458 instead? Should i say at the store for a fet one of this? Or they are all the same
and the jacks, it has 3 rings when i searched for it, and you mentioned only two.
what kind of wire to use?
thnxt in advance, almost getting started!
omg! I still can't find 2n5457! Can i use 2n5458 instead? Should i say at the store for a fet one of this? Or they are all the same
and the jacks, it has 3 rings when i searched for it, and you mentioned only two.
what kind of wire to use?
thnxt in advance, almost getting started!