Maker Pro

Project Logs

Showcase your projects in here by creating a dedicated entry, which automatically creates a discussion thread.
roughshawd
Updated
Views
73
Updates
3
Make a refused error prone frigerator into a modern brewmasters lager box
An in wall subwoofer to add bass in 2 rooms
Sidecar Bob
Updated
Views
604
Among the stuff we removed from our late son's apartment were two subwoofers without the rest of the systems they belong to. I could have bought complete systems for less than the original parts to go with these but they were too good to throw out...
Sidecar Bob
Updated
Views
203
Reaction score
1
I've had this decade box for about half a century and it wasn't new when I got it. When I used it recently I realized that the resistors in it had drifted out of spec so it's time to rebuild it.
It's just a panel of randomly flashing LEDs that mimics props from old Sci-Fi movies & TV.
Sidecar Bob
Updated
Views
213
I'm revisiting a project I made a couple of years ago to improve the housing (& probably make it sound a bit better too).
A 1 day build of a digital millimeter for my bench.
Sidecar Bob
Updated
Views
373
My ancient Heathkit bench supply died a while ago so I bought one of the 30V 3A variable power supply kits like the link below that are all over eBay to replace/upgrade the insides of it with.
TomB19
Views
285
4 Wire Short
TomB19
Views
146
8 ohm amplifier load
Sidecar Bob
Views
217
Reaction score
1
In our family we exchange homemade Xmas cards instead of gifts (much easier to get the right size &c). A few years ago I saw this video and shortly after I came across low voltage strings of LED Xmas lights in a January clearance and the cards my wife & I make haven't been the same since :D My part of the project starts with spray painting some of the folders we make the cards from and then waiting for instructions on where to put the lights. While I'm waiting I cut up a string or 2 of...
Thermal printers are very common in our daily life, and there are examples of thermal printers in restaurants, parking lots and shopping. This article will focus on the application of thermal printers in parking systems.
What we need to do here is such an application, select different modes through STONE Touch Screen, realize the control of MCU through serial port communication, and then realize the speed and rotation time control of stepping motor.
bancroft
Views
514
The smart home is becoming more and more common with the development of technology, this article will focus on the security aspects of the intelligent access control project.
A sonicator is an ultrasonic device that relies on caviation to emulsify and/or extract substances. This example operates at 28 kHz and has a power of 100W.
Miguel Lopez
Views
2K
Reaction score
2
This log describe the steps on building a little and practical vacuum tube based audio amplifier, using Soviet vacuum tubes.
Miguel Lopez
Updated
Views
3K
This generator will produce two fixed frequency signals to test electronic devices. It is based on vacuum tubes
TooFatGeorge
Updated
Views
2K
A remote control that fits in a light switch to send button presses to a Raspberry Pi.
This is a project is about building a midi controlled synth. I will be going through experimentation and planning of such a project. It will be written from my viewpoint, but I will be open to people making suggestions.
FuZZ1L0G1C
Views
2K
Reaction score
6
Uses hi-Z sounder IPO original hi-bright LED, runs from single 1.5V D-cell.
Top