Maker Pro
Maker Pro

0-10V Control

megamonkey

Nov 9, 2012
1
Joined
Nov 9, 2012
Messages
1
Hello there, I found this site while searching google for an answer to my question and hoping some of you guys could help me!

Right so I'm working on a project where I've installed some 630mm fanset to extract heat out of a data centre. However we have a supplier that will provide all the controls for this but there has been a delay in this, now the room is getting hot and I want to power up the fans, these are fed from a 3 phase power board with isolator on but I need to provide a 0-10V signal temporarly before the controls is sorted.

So what I was wondering is if there is something I can purchase/build that will allow me to plug into a standard british 13A Socket, which will produce this 0 to 10V signal (ideally want a dial to vary the signal and thus the fan speed)

Cheers for any help provided!
 
Top