ok, so you don't think the pinouts are for jumpers that enable the protocol for the clock and data system...?
I know that the board says SDA and SCL on it. I just cant find any written confirmation about board configuration.
Its a simple system for simple things, and SCL and SDA are considered simple I guess,, I'm just supposed to know.
I remember some discussion that went like this;
"try it, if it works ok, if it doesn't, there's probably a jumper somewhere that enables it..."
All fine and dandy at 39.99 a pop that trial and error stuff in electronics leaves burn scars sometimes!
I don't want to blow this one up, if you know what I mean! I will keep looking, there is probably an answer there somewhere.