T
[email protected]
- Jan 1, 1970
- 0
I have a circuit board that provides 5 VDC power to some sensors,
reads the analog outputs of the sensors and converts that to an RS-232
signal. The problem is that I did not design in any type of short
circuit on the power supply output of my board. Anyone have a
suggestion to add short circuit protection to the existing board
already made? I'm adding the protection to my new boards, I am
concerned about the ones I already have in stock.
Thanks.
reads the analog outputs of the sensors and converts that to an RS-232
signal. The problem is that I did not design in any type of short
circuit on the power supply output of my board. Anyone have a
suggestion to add short circuit protection to the existing board
already made? I'm adding the protection to my new boards, I am
concerned about the ones I already have in stock.
Thanks.