Maker Pro
Maker Pro

Ademco Vista 250BP Programming to Report Open / Close Events

K

Ken

Jan 1, 1970
0
I am using an ABN broadband interface with NextAlarm. Alarm conditions
report fine, but I am not getting Arm / Disarm or other reports.
Anyone tell me what program fields I must have missed?
 
C

Crash Gordon

Jan 1, 1970
0
Been a while since I've done one of those, but I think it's in the
individual user code programming.


|I am using an ABN broadband interface with NextAlarm. Alarm conditions
| report fine, but I am not getting Arm / Disarm or other reports.
| Anyone tell me what program fields I must have missed?
|
|
 
S

shady

Jan 1, 1970
0
Ken said:
I am using an ABN broadband interface with NextAlarm. Alarm conditions
report fine, but I am not getting Arm / Disarm or other reports.
Anyone tell me what program fields I must have missed?

in the 128bp it's in user code programming... yes/no toggle somewhere in
there... i'll assume it's the same for the 250

and yes... it needs to be done for each and every user (if that's what you
want)... so i hope you don't have too many to change
 
K

Ken

Jan 1, 1970
0
I've used the Symphony AUI to program the users, and have selected the
checkbox to indicate that open and close events are to be sent for the
particular user. I wonder if this either is not working or only
affects activity at that particular AUI.
 
N

Nomen Nescio

Jan 1, 1970
0
Ken said:
I am using an ABN broadband interface with NextAlarm. Alarm conditions
report fine, but I am not getting Arm / Disarm or other reports.
Anyone tell me what program fields I must have missed?

It sounds like you need to go into "Report Code Programming" in #93 menu
mode and check your entries. You'll need to have the book in front of you
as you do this.

- badenov
 
Top