terry said:
Hi,
Do anyone know whether I could input 100V to a CD4052 analog switch
channel which is suppled by 5V? If not, any other analog switch
channel component in the market could do the job?
Thanks!
Yes you could, but it certainly won't survive.
Some switches are designed to withstand fault voltages up to about 40V
*fault* voltage, at the expense of a higher on resistance, but they won't
pass signals beyond their supply rails.
Vishay, Maxim have some and probably all other switches manufacturers have
too and those will always cost you much more than your initial 4052.
What's important to know is : do you have to pass 100V signals or is the
100V a fault condition ?
Anyway, if you can accept a finite input impedance, the way to cope with
high input voltages is to switch between different resistors as the input
resistor in an opamp inverter amplifier if you need very high linearity, or
as the first resistor of a divider followed by a buffered in more standard
cases.
Thanks,
Fred.
