In particular for a life fitness 93TI treadmill. I think I have it figured out but can't seem to remove the cuicut board from the mounting frame/heat sink. So I can't get to the back side to test/remove components. If anyone is able to help out with advice on how to remove it would be much appreciated.
Treadmill does not turn on. Treadmill was working then I moved to another room and it won't turn on. I checked all fuses and reset switches. No display or anything. I have 240 VAC going to the board. But I'm assuming the display works on DCV. There is a component on the board labeled 10A 250V AC / 10A 30V DC. Also a 250 VAC relay. So I'm guessing one of those components is bad.
Control board number: a080-92303-f000 Rev.G
Fyi, I've never done any electronics repair and there is no one in town that does this.
Any ideas how I remove board from frame/heat sink?
Images are two posts down.
Treadmill does not turn on. Treadmill was working then I moved to another room and it won't turn on. I checked all fuses and reset switches. No display or anything. I have 240 VAC going to the board. But I'm assuming the display works on DCV. There is a component on the board labeled 10A 250V AC / 10A 30V DC. Also a 250 VAC relay. So I'm guessing one of those components is bad.
Control board number: a080-92303-f000 Rev.G
Fyi, I've never done any electronics repair and there is no one in town that does this.
Any ideas how I remove board from frame/heat sink?
Images are two posts down.
Last edited: