pityocamptes
- Jul 26, 2012
- 79
- Joined
- Jul 26, 2012
- Messages
- 79
I bought a cheap booster board that has an adj pot for voltage output. I want to remove the pot and instead run it to a resistor box for hardwired (switched) voltage outputs. Can I measure the pot resistance for a specific voltage while the pot is on the board or does the pot have to be removed, once voltage output value is reached and then measure the ohm value on the pot for a comparable resistor value? Oh, and one more thing, the pot has three legs, what should I do with the 3rd leg when I hard wire in a resistor selection box? Thanks!