Jamie Cullen
- May 2, 2016
- 4
- Joined
- May 2, 2016
- Messages
- 4
The one of two plastic clips holding the on/off circuit board switch broke and no longer holds the button in place. The button does still work when manually held in place. How can I fix this so that the button will be held in place and responds to being pushed on and off?
The top part/latching part of the clip broke and I was thinking of just putting a drop of crazy glue from the top of the broken clip onto the circuit board where the clip would have been. The clip broke off flush with the top of the circuit board. I an not sure if this will be effective?
The broken clip is in diagonally across from the intact clip. in the lower right of the more verticle pictures.
Thanks,
Jamie
The top part/latching part of the clip broke and I was thinking of just putting a drop of crazy glue from the top of the broken clip onto the circuit board where the clip would have been. The clip broke off flush with the top of the circuit board. I an not sure if this will be effective?
The broken clip is in diagonally across from the intact clip. in the lower right of the more verticle pictures.
Thanks,
Jamie
Attachments
Last edited: