Maker Pro
Maker Pro

Car TV Monitor, Blown fuse

Rick79

Nov 26, 2014
283
Joined
Nov 26, 2014
Messages
283
I have two Pyle Brand TV monitors and one of them recently blown its fuse. I tried the fuse from the other monitor to see if it just needed a new fuse, but it blew that one two. I checked the wires and looked around the board for any shorts and I noticed the diode is reading bad. My question is, can a bad diode cause the fuse to blow? Would that be the only component that would most likely fail? I only have a multimeter so i can't test the capacitors.
 

Attachments

  • IMG_20170827_124703.jpg
    IMG_20170827_124703.jpg
    128.8 KB · Views: 82
  • IMG_20170827_124650.jpg
    IMG_20170827_124650.jpg
    175.1 KB · Views: 101
  • IMG_20170827_124731.jpg
    IMG_20170827_124731.jpg
    109.9 KB · Views: 85

kellys_eye

Jun 25, 2010
6,514
Joined
Jun 25, 2010
Messages
6,514
The diode is often wired across the supply lines to form a deliberate short in the event of wrong polarity connection. You can snip one end of the diode out of circuit to test that the rest of it still works as it should.

Ideally, and to restore safety, you should replace the diode.
 

Rick79

Nov 26, 2014
283
Joined
Nov 26, 2014
Messages
283
The diode is often wired across the supply lines to form a deliberate short in the event of wrong polarity connection. You can snip one end of the diode out of circuit to test that the rest of it still works as it should.

Ideally, and to restore safety, you should replace the diode.

Thank you! Can you tell by the photo what kind of diode that is?
 

Bluejets

Oct 5, 2014
6,901
Joined
Oct 5, 2014
Messages
6,901
Read the number when you snip it to test out of circuit then Google.
 

Rick79

Nov 26, 2014
283
Joined
Nov 26, 2014
Messages
283
I cut one end of the diode and tried another fuse, but it blew again.
I saw that i can disconnect the fuse boxes from the cable, so I swapped fuse boxes with the other one and then the fuse blew on that one too. I knew that box was good, so using continuity on the meter, i found out the cable has a short. Great
 

Bluejets

Oct 5, 2014
6,901
Joined
Oct 5, 2014
Messages
6,901
Bit of a tip when you have a known short somewhere you are trying to eliminate. Instead of blowing fuses continually, place a bulb in series. In your instance about 10w. When bulb is bright, short still present.
 

Rick79

Nov 26, 2014
283
Joined
Nov 26, 2014
Messages
283
Bit of a tip when you have a known short somewhere you are trying to eliminate. Instead of blowing fuses continually, place a bulb in series. In your instance about 10w. When bulb is bright, short still present.

Thanks
 
Top