Maker Pro
Maker Pro

Circuit Analysis advice

leeb_965

Feb 5, 2012
34
Joined
Feb 5, 2012
Messages
34
Hi,

say you have built a circuit in which the objective was specified and carried out. How would you go about explaining the circuit?

also how would you analyze the circuit? What results would you show?

Kind Regards
Lee
 

poor mystic

Apr 8, 2011
1,074
Joined
Apr 8, 2011
Messages
1,074
Hello Leeb:)
I would give a different explanation to my mother, than I would give on this forum, so I think that a critical question is: "Who is your audience?"

PS You could put the circuit up here for us to analyse and see if we can help more directly.
 
Last edited:

leeb_965

Feb 5, 2012
34
Joined
Feb 5, 2012
Messages
34
Yeah sure, see the attached.

If you cant make it out it goes from left to right as

1) full-bridge circuit
2) 3 op-amp instrumentation amplifier
3) Phase sensitive detector switched by a CMOS 4066 and driven by a square wave from LM311 comparator

This is for a university presentation.

Thanks

also its not finished yet so after the PSD will be a low pass filter then a howland current source.
 

Attachments

  • mycircuit.jpg
    mycircuit.jpg
    52.7 KB · Views: 550

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
I would consider drawing a block diagram and explaining the various functional blocks and how they achieve the desired result before showing the contents of these functional blocks and explaining how each of them implements the function.

It may be necessary to discuss the interaction between functional blocks if certain voltage levels or impedance matching is required.

(And I've moved this to homework help where it seems to belong)
 
Top