Hi everyone, its been a while and I finally got my driver. I am having some trouble wiring my 6 wire motors to the 4 plugins... I have tried lots of different wiring configurations and all i get is the motors locking when I trigger E-stop (this happens no matter how I wire it). I have confirmed the signal is getting from the computer to the board as when I try to jog the motors the "active" light, lights up on the board. I do know that as I am wiring up a 6 wire motor to a 4 wire port that I have to leave out the center tap wires, but even if i leave them wired up it should at least do something, or is my understanding of the motors incorrect. Does anyone have any suggestions as to what I might try???
NOTE: this is the driver I have: http://www.ebay.ca/itm/TB6560-CNC-3...858?pt=LH_DefaultDomain_0&hash=item2321573992
Thanks
NOTE: this is the driver I have: http://www.ebay.ca/itm/TB6560-CNC-3...858?pt=LH_DefaultDomain_0&hash=item2321573992
Thanks