Maker Pro
Maker Pro

Confused by marking of Power Mosfets

  • Thread starter Friedrich Schübeck
  • Start date
F

Friedrich Schübeck

Jan 1, 1970
0
Dear Sirs!
I want to repair electronic ballasts.
In the same type of ballast (TRILUX) i found a lot of different Mosfets,
most from Int.Rectifier:
IR822G,824G,826G/C, 831C, 851C, 852 F, 907C, 910C 912C, IRFBE30, IRF 820,
IRF 830.
Only the three last ones are listed and available.
I cannot find datas from the other types.
Is it an agreement between the manufactures?
Is it possible to replace them with one cheap replacement transistor?
In average i have to replace 2 transistors and a safety resistor for every
ballast.
At a price of 3 to 5 Euro (1 Euro= 1.19 US$) for one transistor it does not
pay to repair the devices with defective Mosfets.
Excuse my bad English!

Thank You!

Best regards,

Friedrich.
 
You can get much better prices if you buy them in quantity, or shop on
eBay (carefully).

But the whole idea of repairing ballasts is fraught with hazards-- I
don't know the laws in your country, but here if one of your ballasts
ever burns up and causes any damage, you're probably personally liable.
If you're doing this at your work, I'm pretty sure your company's
insurer would frown on this. There's just too much risk (millions of
dollars) for the savings (very small, if at all). Even if you value
your time at $5 an hour, you're losing money on each one.
 
J

James Sweet

Jan 1, 1970
0
You can get much better prices if you buy them in quantity, or shop on
eBay (carefully).

But the whole idea of repairing ballasts is fraught with hazards-- I
don't know the laws in your country, but here if one of your ballasts
ever burns up and causes any damage, you're probably personally liable.
If you're doing this at your work, I'm pretty sure your company's
insurer would frown on this. There's just too much risk (millions of
dollars) for the savings (very small, if at all). Even if you value
your time at $5 an hour, you're losing money on each one.


There's no more liability associated with repairing ballasts than there
is repairing any other line operated appliance. Just do the job right
and don't substitute or bypass any safety critical parts.
 
Top