I'm attempting to use a DC wall adapter to drive a circuit. I'm integrating into my circuit, so I pulled apart the casing. I would like to have 800 watts running through it, but the resistance of the primary coil is approximately 135, far to high to draw the necessary 6.66 amps needed to achieve 800 watts at 120 volts. Is there some sort of resistor inside the coil that I could remove? If I removed it, would there be issues with running the transformer? My input would be 120 Volts at 6.66 Amps, and my output would be 18 Volts at 44.44 amps. I don't know if the secondary coil can handle 44 amps. It would only be run for a short period of time, and would remain as a part of this project, instead of a potential fire hazard.
-
Categories
-
Platforms
-
Content