Maker Pro
Maker Pro

Desolder Motorola Components

I repair Motorola 2-way radios and am having difficulty desoldering
some of the components. For example, when desoldering a 6-pin channel
select switch, the outer pair of legs are removed easily. However, the
solder does not flow on the center pair of legs. I have tried
increasing the temperature and flux.

Any suggestions?

Thanks!
 
T

Travis Jordan

Jan 1, 1970
0
I repair Motorola 2-way radios and am having difficulty desoldering
Any suggestions?

The switch pins may be using 'through hole' connections.

Have you tried a desoldering iron with vacuum pump?
 
D

Doug

Jan 1, 1970
0
Since the old switch is bad cut the legs off and remove one leg at a
time.
If you cant get to the legs break the switch with pliers or vice grips.
Doug
 
M

maxfoo

Jan 1, 1970
0
I repair Motorola 2-way radios and am having difficulty desoldering
some of the components. For example, when desoldering a 6-pin channel
select switch, the outer pair of legs are removed easily. However, the
solder does not flow on the center pair of legs. I have tried
increasing the temperature and flux.

Any suggestions?

Thanks!

Use a hot air gun, silly...
 
C

Clifford Heath

Jan 1, 1970
0
Any suggestions?

A technique I've used with SM ICs is to poke a fine
wire under all the pins on one side, and solder the
end down to a nearby pad or via. Then apply heat to
the pins while pulling sideways on the other end of
the wire, which lifts the pins one by one.
 
J

John Woodgate

Jan 1, 1970
0
I read in sci.electronics.design that Clifford Heath
A technique I've used with SM ICs is to poke a fine
wire under all the pins on one side, and solder the
end down to a nearby pad or via. Then apply heat to
the pins while pulling sideways on the other end of
the wire, which lifts the pins one by one.

It would work better if the wire didn't take solder, such as a fine
Nichrome or stainless steel wire. Of course, you have to loop it round
something to anchor the end. Dig out your old wire recorder!
 
Top