B
bob
- Jan 1, 1970
- 0
I'm using 1n5404 diodes to clamp the inductive load for a coil gun
project.
The diodes' surge current is rated at 200 amps for 8.3 ms. The current
that I need to clamp starts off at a peak of 500 to 700 amps and
becomes 0 in about less than half a millisecond. Can the 1n5404 safely
handle this much current? Will the forward recovery time of the diode
cause any problem in quenching the built up current?"
-Thanks in
advance
Yale
project.
The diodes' surge current is rated at 200 amps for 8.3 ms. The current
that I need to clamp starts off at a peak of 500 to 700 amps and
becomes 0 in about less than half a millisecond. Can the 1n5404 safely
handle this much current? Will the forward recovery time of the diode
cause any problem in quenching the built up current?"
-Thanks in
advance
Yale