Maker Pro
Maker Pro

Display problem with Tektronix TAS250 scope

ghale3

May 1, 2011
1
Joined
May 1, 2011
Messages
1
Perhaps someone can help me, or at least point me in the right direction to look. My scope has lost it's cursor readout. This is an overseas unit that Tektronix sold and I cannot find a schematic or much information on it at all. I am wondering if it is better to just replace it, though I have always liked it. Any help would be appreciated.
 

davenn

Moderator
Sep 5, 2009
14,254
Joined
Sep 5, 2009
Messages
14,254
I have the same problem with Tektronix TAS 250 oscilloscope. Cursor does not show up on the dispaly anymore. Can you help me to solve the problem ? Thanks!

Hi there
welcome to the forums :)

do as I suggested in my previous message and that you quoted :)
there are many many subscribers to that yahoo group with lots of good info

Dave
 
Top