Maker Pro
Maker Pro

Dummy load needed

Edsgns

Dec 23, 2016
1
Joined
Dec 23, 2016
Messages
1
I am working on a project to clown a coworker. It includes 3 light sockets, 3 switches and an ammeter to show the current draw of each bulb. The bulbs to be used are one led (draws 20 watts), one incandescent bulb (25 watts) and one compact fluorescent (20 watts). The ammeter ranges from 0-1 amp. What I am trying to do is make the ammeter show around .8 amps+ When I turn on the fluorescent. Using ohms law on a 120 volt circuit to calculate the resistance (R=V/I) R = 120/.8 so I need 150 ohms. I have an 150 ohm 10 watt resistor but not sure that the 10 watts is enough.
 
Top