S
sg
- Jan 1, 1970
- 0
We are looking for engineering assistance developing a ARM SoC PCB for
a commercial product.
Ideal candidate will be US based, Chicago area a big plus.
Demonstrated experience in pcb design with ARM SoC's, with some
references of past work.
Company Engineer who is looking to make some side money, or graduate EE
student perhaps.
///
Rough requirements are (more details will be provided after NDA
ARM SoC @200mhz - @400mhz
Board to run Linux (with CE support also a plus)
On Board GPS + Antenna (Trimble or Sirf or ?) ARM connected to GPS via
serial/UART.
AC97 audio, line in for microphones(s)
Mono Audio amplifier @ 500mW
Circuiry for LiIon charging / power managment
16mb Ram
16-32mb Flash
///
Due to product design, we need to keep this as compact as possible.
Ideal board size would be 120mm*40mm*7mm (with LiIon battery located
elsewhere)
We may also want to investigate two (or three ?) boards connected with
a flex ribbon.
We need production ready designs, gerber/orcad or eqiv pcb layout.
Designs must me free of IP rights and Royalty free.
We will handle manufacturing.
We will pay a good industry standard rate for this, timeline is PCB
prototype development by April 06 or sooner.
Contact [email protected] if you can do this.
a commercial product.
Ideal candidate will be US based, Chicago area a big plus.
Demonstrated experience in pcb design with ARM SoC's, with some
references of past work.
Company Engineer who is looking to make some side money, or graduate EE
student perhaps.
///
Rough requirements are (more details will be provided after NDA
ARM SoC @200mhz - @400mhz
Board to run Linux (with CE support also a plus)
On Board GPS + Antenna (Trimble or Sirf or ?) ARM connected to GPS via
serial/UART.
AC97 audio, line in for microphones(s)
Mono Audio amplifier @ 500mW
Circuiry for LiIon charging / power managment
16mb Ram
16-32mb Flash
///
Due to product design, we need to keep this as compact as possible.
Ideal board size would be 120mm*40mm*7mm (with LiIon battery located
elsewhere)
We may also want to investigate two (or three ?) boards connected with
a flex ribbon.
We need production ready designs, gerber/orcad or eqiv pcb layout.
Designs must me free of IP rights and Royalty free.
We will handle manufacturing.
We will pay a good industry standard rate for this, timeline is PCB
prototype development by April 06 or sooner.
Contact [email protected] if you can do this.