Maker Pro
Maker Pro

Ever 'souped up' the ADC on Renesas uC?

M

Meindert Sprang

Jan 1, 1970
0
Joerg said:
Hello Joep,



I always do. In fact, when the layout guidelines section of the data
sheet starts I usually stop reading ;-)

Well guys, thanks for all the input. Especially that document Joep referred
to, was very interesting. As for my design, I now have one single grounplane
and all DGND and AGND pins are all connected to them through their own via,
less than 0,5mm away from each pad. And indeed Joerg, it saved me a lot of
aspirin :)

Meindert
 
J

Joerg

Jan 1, 1970
0
Hello Meindert,
Well guys, thanks for all the input. Especially that document Joep referred
to, was very interesting. As for my design, I now have one single grounplane
and all DGND and AGND pins are all connected to them through their own via,
less than 0,5mm away from each pad. And indeed Joerg, it saved me a lot of
aspirin :)

Great. But you guys don't have to worry about Aspirin since you've
already got Hoegaarden and Beerenburger :-D

Regards, Joerg
 
M

Meindert Sprang

Jan 1, 1970
0
Joerg said:
Hello Meindert,
Great. But you guys don't have to worry about Aspirin since you've
already got Hoegaarden and Beerenburger :-D

Yuck, I don't like Beerenburgen (anymore). Been very drunk once from that
stuff.....
Hertog Jan is my favourite beer and as for the stronger stuff, you may wake
me up any time for a good Islay whisky.. :))

Cheers,
Meindert
 
Top