Maker Pro
Maker Pro

Ex-Genius needs help

VictorTango

Jul 8, 2009
1
Joined
Jul 8, 2009
Messages
1
I am working on a project and I need a bit of help. Here's the scenario;

I am using a CYC63743C USB controller and want to run an isolated 17V relay. I am trying to use a 4n35 optocoupler to run the relay but can't seem to get the 4n35 to fire (or so it seems). I have tried using a 1k resister (and many other values) in line with the 5v i/o pin on the USB controller but can't get the relay to fire (on the output side of the 4n35). I believe I have everything wired correctly as far as polaruty is concerned.

Perhaps I am incorrect in believing I can use the 4n35 to act like an analog switch. I need some way of firing the 17V relay and definately want an isolated circuit. Anybody have any ideas? I need to keep it as low cost as possible.

:confused:
 

neon

Oct 21, 2006
1,325
Joined
Oct 21, 2006
Messages
1,325
a rerlay means mucho power you are killing the 4n35 try to add a power transistor or some kind of power driver then it will work.
 
Top