Maker Pro
Maker Pro

find faulty component in printed circuit board.

kevinkhan

Sep 26, 2013
4
Joined
Sep 26, 2013
Messages
4
Looking for someone to help me find a faulty component in a printed circuit board used in a american dual gem disco light.

The circuit board has only a number of components in it so should be easy to debug the problem (for someone that knows what there doing :)
 

Harald Kapp

Moderator
Moderator
Nov 17, 2011
13,700
Joined
Nov 17, 2011
Messages
13,700
Welcome to electronicspoint.

Start by showing us a picture of both sides of the PCB so we can look out for any visible defects.
You can also help by describing the faulty behavior in more detail.
 

davenn

Moderator
Sep 5, 2009
14,254
Joined
Sep 5, 2009
Messages
14,254
and if you have or can get any circuit diagrams, that would be even more helpful
 

kevinkhan

Sep 26, 2013
4
Joined
Sep 26, 2013
Messages
4
ok thanks for your reply guys.

Attached is a circuit diagram for the light and also a picture of the printed circuit board front and back.

The voltage regulator was damaged so i replaced this but now there most be another damaged component.

At the moment when i turn on power all the led light in the disco light light up but dont flash. In a working light when i turn on the power the led lights turn on and off and also speeds up and slows down when there is music on.

Any help would be greatly appreciated.

Thanks
 

Attachments

  • 20150331_082846.jpg
    20150331_082846.jpg
    291 KB · Views: 121
  • 20150331_082901.jpg
    20150331_082901.jpg
    183.5 KB · Views: 107
  • Dual Gem Led Page 2.pdf
    50.2 KB · Views: 98
  • Dual Gem LED.pdf
    99.7 KB · Views: 77
  • E_dual-gem-led.pdf
    580.2 KB · Views: 102
Top