D
Don A. Gilmore
- Jan 1, 1970
- 0
Hi guys:
I have an application where I have 24 independently-operated push solenoids
(very small tubulars) that are rated at 12 Vdc, continuous operation. To
make them operate properly in my device, I need to deliver a 4x voltage
pulse (48 volts) to the solenoid for a very short period (maybe 10 ms) then
revert to 12 V to hold the solenoid extended while it is in use. This must
occur every time it is fired. I will have both 12 V and 48 V sources
available on the PCB and the circuit is controlled with CMOS.
What is the simplest way to do this? Thanks for all replies.
Don
Kansas City
I have an application where I have 24 independently-operated push solenoids
(very small tubulars) that are rated at 12 Vdc, continuous operation. To
make them operate properly in my device, I need to deliver a 4x voltage
pulse (48 volts) to the solenoid for a very short period (maybe 10 ms) then
revert to 12 V to hold the solenoid extended while it is in use. This must
occur every time it is fired. I will have both 12 V and 48 V sources
available on the PCB and the circuit is controlled with CMOS.
What is the simplest way to do this? Thanks for all replies.
Don
Kansas City