Maker Pro
Maker Pro

Help!!Elenco XK 300 micro controller system

Memyself

Dec 11, 2015
1
Joined
Dec 11, 2015
Messages
1
Hi,
I just got an old Elenco XK 300 micro controller system from my grandparents. It comes with some very hard to understand instructions, which aren't any help. Does anybody know anything about this or where I could find info about it. Thanks so much.
 

dorke

Jun 20, 2015
2,342
Joined
Jun 20, 2015
Messages
2,342
Try contacting Elenco directly here.

Here is some very basic info on it ,and here is the MEK6802 board it is based on.

If there is something specific you need,come back and ask.

BTW,
This is 1980 stuff,what do you intend to use it for?
You can do much better and with greater ease with modern uC boards .
 

CDRIVE

Hauling 10' pipe on a Trek Shift3
May 8, 2012
4,960
Joined
May 8, 2012
Messages
4,960
BTW,
This is 1980 stuff,what do you intend to use it for?
You can do much better and with greater ease with modern uC boards .

It sure is but how does he break that news to his grandparents without appearing ungrateful?

Chris
 

dorke

Jun 20, 2015
2,342
Joined
Jun 20, 2015
Messages
2,342
It sure is but how does he break that news to his grandparents without appearing ungrateful?

Chris


Well, that is quit simple:
Grandpa/ma that is a great gift I'm grateful,:)
but did you now it only has...hold tight, 128 bytes(!-no mistake) of RAM ? o_O
 

CDRIVE

Hauling 10' pipe on a Trek Shift3
May 8, 2012
4,960
Joined
May 8, 2012
Messages
4,960
Well, that is quit simple:
Grandpa/ma that is a great gift I'm grateful,:)
but did you now it only has...hold tight, 128 bytes(!-no mistake) of RAM ? o_O
Grandma & Grandpa's response: "A Ram bit who 128 times"?? :p

Chris
 
Top