Help Identifying MOSFET ?

[Chemelec]

Thanks again everyone


I tested them by putting the multimeter on the resistance setting and then measured across the two outer legs.

Ill but the ones i linked to and see if it fixes it.

YOU CAN'T TEST THESE MOSFETS "IN CIRCUIT" like that.

That would be a Test from "Gate to Source" and your actually reading the Resistance of Other Parts on the Circuit Board.

 

[Inked]

YOU CAN'T TEST THESE MOSFETS "IN CIRCUIT" like that.

That would be a Test from "Gate to Source" and your actually reading the Resistance of Other Parts on the Circuit Board.

Either way they were in bad condition so they will need to be changed anyway

 

[Chemelec]

Either way they were in bad condition so they will need to be changed anyway

They DON'T Look Bad in your Picture.

Since you Don't know the Exact Specifications of the Original MOSFET's, Your just Compounding the problem of obtaining a Correct Repair.

 

[Inked]

They DON'T Look Bad in your Picture.

Since you Don't know the Exact Specifications of the Original MOSFET's, Your just Compounding the problem of obtaining a Correct Repair.

The picture was of the good ones were we could still read the numbers.

 

[Chemelec]

The picture was of the good ones were we could still read the numbers.

Well if you Can't read the Numbers, STOP THERE.
Just because parts look the same, Does NOT mean they are.

And I have some NEW Parts, that are Difficult to read the Numbers on them,

 

[mrcevall]

I think is this one or very similar
http://pdf1.alldatasheet.es/datasheet-pdf/view/418989/INFINEON/IPB070N08N3G.html

 

[Gandes]

Try to look at chineese shops