Maker Pro
Maker Pro

HELP with Schematics for magnet launcher

Status
Not open for further replies.

CLD

Jul 9, 2019
2
Joined
Jul 9, 2019
Messages
2
I am recreating the induction launcher in this YouTube vid:

I have all of the parts:
2 tranformers
4 resistors
bridge rectifier
4 capacitors
SCR
Switch
Electromagnet coil

I don't know how to read the schematics - HOW do I connect all of the parts and where for each?

Get back to me so we can talk about it.
Thanks

IT WONT ALLOW METO UPLOAD PICS!!!!
 

Bluejets

Oct 5, 2014
6,865
Joined
Oct 5, 2014
Messages
6,865
IT WONT ALLOW METO UPLOAD PICS!!!!

It is an accepted fact that capital letters and exclamation marks are considered as shouting which no one appreciates and will normally get you very little of your intended attention.
It is also obvious the link did not upload either.
 

davenn

Moderator
Sep 5, 2009
14,241
Joined
Sep 5, 2009
Messages
14,241
IT WONT ALLOW METO UPLOAD PICS!!!!

your image was probably too big (physically)
make sure images are .jpg and less than 1024 x 768, preferably ~ 800x600 and 100kb or less
 

Alec_t

Jul 7, 2015
3,584
Joined
Jul 7, 2015
Messages
3,584
If it's the same circuit you were considering over at AAC, it's potentially lethal nature has already been pointed out! It would likely infringe the Terms and Conditions of this site.
 

Audioguru

Sep 24, 2016
3,656
Joined
Sep 24, 2016
Messages
3,656
The noob thinks the random parts he bought will not explode or set his house on fire!
 
Status
Not open for further replies.
Top