S
[email protected]
- Jan 1, 1970
- 0
Hello,
I'm trying to message a transducers time of flight. The transducer has
two leads and has an operating frequency of 40 kHz. I would like to
see the reflected wave vary when I move the target with respect to the
initial pulse . I just don't know how to setup my equipment to do
this. Could someone please tell me how to do this and if is the wrong
forum please let me know where I should post this question.
Thanks for any and all help.
Best regards,
Ken
I have the following equipment:
Tektronix TDS 3012B scope
Tektronix 2246 scope
B&k 3011 2MHz function generator
Wavetek 4 MHz sweep/ function generator
101 Pulse generator
I'm trying to message a transducers time of flight. The transducer has
two leads and has an operating frequency of 40 kHz. I would like to
see the reflected wave vary when I move the target with respect to the
initial pulse . I just don't know how to setup my equipment to do
this. Could someone please tell me how to do this and if is the wrong
forum please let me know where I should post this question.
Thanks for any and all help.
Best regards,
Ken
I have the following equipment:
Tektronix TDS 3012B scope
Tektronix 2246 scope
B&k 3011 2MHz function generator
Wavetek 4 MHz sweep/ function generator
101 Pulse generator