Maker Pro
Maker Pro

how to short through caps

Status
Not open for further replies.

dragon

Oct 31, 2022
248
Joined
Oct 31, 2022
Messages
248
Capacitors are highly resistive and they lag and ramp.

But I just fixed my whole reportoire!!!

If you always use caps when they are charged backwards, and u abort with a diode when they are grounded,
whenever you travel through the cap it has 0 resistance!!!
So u can short through them!!!!

I was stuck going slowly and half crossed with my other channels/activities until I worked this out.
So I'll see how it goes, I wonder how much more I've got to learn before I get something decent done.

I can still do it similar to my old style with resistively using the caps, if I just add a bit of bias, put it in back and forth for my power,
then any time I short a power to discharge a cap it starts going backwards to develop the negative resistance again.

Much improved. I dont think there is any other way to use em, but I spose I need to go proove all this stuff for real yet.

So there needent be resistance when ur using your caps, if u make sure they are always ready before u use them.
 
Status
Not open for further replies.
Top