http://imageshack.us/photo/my-images/545/jvb8148.jpg/
I found this in somebody junk:
It is connected to 240V with (smaller) black and yellow whire. But this is done with tape only..
The guy told me this psu should be good.
I do not get any serious voltage out of this coil. Exept from the green and the red whire it gives 230V the ones low. The other wires give voltages like 1.24 at most AC. I doubt it is hooked up properly.
Is there any way to test it with a basic multimiter where the 240V voltage should be hooked up So I can see what psu has to deliver.
I am asking because I am building a labo psu, but the re-used amplifier psu is a bit to weak. So I took this psu out of garbage, but do not know anything about it, exept it came from a broken amplifier. The guy who kept it said it was good, the amp had some transistor failure.
I found this in somebody junk:
It is connected to 240V with (smaller) black and yellow whire. But this is done with tape only..
The guy told me this psu should be good.
I do not get any serious voltage out of this coil. Exept from the green and the red whire it gives 230V the ones low. The other wires give voltages like 1.24 at most AC. I doubt it is hooked up properly.
Is there any way to test it with a basic multimiter where the 240V voltage should be hooked up So I can see what psu has to deliver.
I am asking because I am building a labo psu, but the re-used amplifier psu is a bit to weak. So I took this psu out of garbage, but do not know anything about it, exept it came from a broken amplifier. The guy who kept it said it was good, the amp had some transistor failure.
Last edited: