Hi everyone.
I bought an induction hob about 6 years ago, and it always worked great... Until now! It developed an intermittent fault. When I turn it on, it works normally, but then starts showing up three horizontal lines, and stops heating for a while. Then those lines go away, and it works normally again, but this is repeated over and over while cooking. I took it to repair, and they told me it needed new PCB's, which would cost me over €500. I'm almost sure it doesn't need new PCB's, because it has 2 PCB's, each one for 2 burners, and as this problem is happening in all 4 burners, I don't think they would both develop the same problem at the same time... This looks like a controller problem or something... Has anyone experienced something like this? And can anyone tell me how to fix it?
Thanks!
I bought an induction hob about 6 years ago, and it always worked great... Until now! It developed an intermittent fault. When I turn it on, it works normally, but then starts showing up three horizontal lines, and stops heating for a while. Then those lines go away, and it works normally again, but this is repeated over and over while cooking. I took it to repair, and they told me it needed new PCB's, which would cost me over €500. I'm almost sure it doesn't need new PCB's, because it has 2 PCB's, each one for 2 burners, and as this problem is happening in all 4 burners, I don't think they would both develop the same problem at the same time... This looks like a controller problem or something... Has anyone experienced something like this? And can anyone tell me how to fix it?
Thanks!
