M
Michael
- Jan 1, 1970
- 0
I'm going nuts trying to figure out the pinout on a ired rcvr module....the
Sharp GP1UM281YK.
The data sheet is contradictory.
This is a little stand up module that has 2 mounting flanges and then a 3
pin configuration.
Aren't these an industry standard pinout?....sharp, lite-on etc.?
Is this it......as you look at the front where the lens is the 3 pins would
read left to right.....
output Vcc ground
right? wrong?
I now see an everlight part that looks close to the sharp and it's.....
output ground vcc (front view)
anyone have any experience with this part?
thanks.
Sharp GP1UM281YK.
The data sheet is contradictory.
This is a little stand up module that has 2 mounting flanges and then a 3
pin configuration.
Aren't these an industry standard pinout?....sharp, lite-on etc.?
Is this it......as you look at the front where the lens is the 3 pins would
read left to right.....
output Vcc ground
right? wrong?
I now see an everlight part that looks close to the sharp and it's.....
output ground vcc (front view)
anyone have any experience with this part?
thanks.