I am having a problem with the temp and fuel gauge on my tractor. When the engine is off and the battery is disconnected the gauges do not return to cold/empty. All grounds/connections are clean and fuses good. When I disconnect the 2 leads at the fuel sender, with battery connected and ignition on, and touch the leads together the needle goes to full. When just disconnected leads the needle is at 1/4. The gauges are in a container, so I cannot see inside. Any suggestions why the needles are not returning to cold/empty?
When the power is on the temp gauge goes to red hot and the fuel gauge past the full mark.
if i bypass the temp. sender it does the same when i ground the cable.
picanoor
When the power is on the temp gauge goes to red hot and the fuel gauge past the full mark.
if i bypass the temp. sender it does the same when i ground the cable.
picanoor