Maker Pro
Maker Pro

LED RGB control via analogue input?

Wilky

Jul 6, 2011
2
Joined
Jul 6, 2011
Messages
2
Hi all,

I have a set of RGB LEDs and controller that were 'left over' from a recent project. Please see below pics of the controller, it has two controls, one doing mode (constant / fade / flash etc) and one for speed.

I would like to know if there is any way to control the R,G and B LED outputs by an analogue 1-10V input signal rather than the control buttons, after de-lidding i have seen there is a set of terminals labelled 'input'; R, G, B, and +. Could it be that this is just what i need?

P1040444.jpg


P1040445.jpg


P1040446.jpg


Many thanks.
 

MagicMatt

Jun 15, 2011
70
Joined
Jun 15, 2011
Messages
70
I'm pretty sure that input is going to be digital I/O. I've seen these things before, and that socket is for linking to other devices so that it can synchronise. I think you can link multiple LT-310's together so they all synchronise for using with longer LED chains etc.
 

Wilky

Jul 6, 2011
2
Joined
Jul 6, 2011
Messages
2
Ok, thanks for the reply. I think you are right - I know these can be used as master / slave.
 
Top