Hi all,
I have a set of RGB LEDs and controller that were 'left over' from a recent project. Please see below pics of the controller, it has two controls, one doing mode (constant / fade / flash etc) and one for speed.
I would like to know if there is any way to control the R,G and B LED outputs by an analogue 1-10V input signal rather than the control buttons, after de-lidding i have seen there is a set of terminals labelled 'input'; R, G, B, and +. Could it be that this is just what i need?
Many thanks.
I have a set of RGB LEDs and controller that were 'left over' from a recent project. Please see below pics of the controller, it has two controls, one doing mode (constant / fade / flash etc) and one for speed.
I would like to know if there is any way to control the R,G and B LED outputs by an analogue 1-10V input signal rather than the control buttons, after de-lidding i have seen there is a set of terminals labelled 'input'; R, G, B, and +. Could it be that this is just what i need?
Many thanks.