Maker Pro
Maker Pro

LED

V

Vince

Jan 1, 1970
0
Hi!
This set is a magnavox kitchen TV DVD AM FM MdlMDR700137 , the screen is
dark but if you shine light on it you can see the picture, the contrast
and brightness don't have any effect on it , I need to know what kind of
source it uses to light up the screen,
Thank you
Vince
 
J

James Sweet

Jan 1, 1970
0
Vince said:
Hi!
This set is a magnavox kitchen TV DVD AM FM MdlMDR700137 , the screen is
dark but if you shine light on it you can see the picture, the contrast
and brightness don't have any effect on it , I need to know what kind of
source it uses to light up the screen,
Thank you
Vince


Most of them use CCFL tubes. If you open it up and look at it, it should
be obvious. Inverter failure is common but the tubes can wear out too.
 
U

Usual Suspect

Jan 1, 1970
0
James Sweet sez:
Most of them use CCFL tubes. If you open it up and look at it, it should
be obvious. Inverter failure is common but the tubes can wear out too.

To add a little detail...

The CCFL is a thin (some as small as 1/4 inch diameter) fluorescent lamp that
runs the entire width (usually) of the bottom of the screen. It's usually
taped tightly to the screen with copper tape and not always easily
accessible. I'd bet it's the driver board (inverter) that has failed. This is
much more accessible and I'd test the output of this before tearing apart the
display to get at the bulb.

Good luck,
 
J

Jumpster Jiver

Jan 1, 1970
0
Usual said:
James Sweet sez:




To add a little detail...

The CCFL is a thin (some as small as 1/4 inch diameter) fluorescent lamp that
runs the entire width (usually) of the bottom of the screen. It's usually
taped tightly to the screen with copper tape and not always easily
accessible. I'd bet it's the driver board (inverter) that has failed. This is
much more accessible and I'd test the output of this before tearing apart the
display to get at the bulb.

Good luck,
The inverter output is highfrequency and voltage and may damage some
digital meters.
 
J

James Sweet

Jan 1, 1970
0
Jumpster said:
The inverter output is highfrequency and voltage and may damage some
digital meters.


Easiest to test with another lamp, you don't have to install it in the
display to test the inverter.
 
Top