All said:
Hi
I want to take the output from a walkman and put both channels into a mono
guitar amp but with a pot to adjust the balance.
Any ideas?
I'm not looking for any fancy cct's it is for monitoring purposes only.
I thought of running both o/p's to a pot and taking the wiper to the amp but
not sure what value to make the pot and whether the walkman would object to
having left and right joined even though it's via a resistor.
Any help appreciated.
B Bear
As for joining two channels, I have an IT guy brother-in-law who just flat
shorts left and right together all the time. He, too, plays guitar, and
is the lead "singer" for a garage band named "Green Apple". Anywhoo, he
does that all the time with no problems, I assume, because he still does
it.
Still, I don't know what your amp is designed for, but my brother in law's
guitar runs at approximately microphone-level voltage, and your walkman's
output is closer to line-level voltage. Guaranteed clipping.
I have a radio transmitter here that takes microphone level monaural
input. I fitted two resistors, one on each stereo leg, and tied the
opposite ends together to make it one channel -- works fine, and barely --
just barely -- fits inside a 1/8" stereo plug for use with whatever I
like. The resistors are both standard 1/4-watt carbon film,
red-purple-yellow-gold, so that's what, 270 kilohm, 10% tolerance. Works
GREAT for *my* needs.
Now, you want some kind of pot to do the "balance" thing, and your idea of
using the slider as the amp-side should work fine, in my non-expert
opinion. If you want roughly 270 k-ohm for each, then that's about 540
k-ohm total. You probably won't get that, but you might be able to get a
1 megohm to work. Problem then is the volume might be a little low when
it's centered, and with ANY pot, when you put it hard over left or right,
you'll wind up with NO resistance on that "channel", hence clipping. So
you might want resistors inline with the pot. Perhaps a 100K-ohm pot,
with 120k resistors on either side?
I don't see any way to /simply/ cut out either channel without some volume
problems, though. If you wanted to make a simple mixer, it's very easy.
Just need a few pots, a few discrete resistors and caps, and a couple very
inexpensive (<$2.00 each) IC chips. Then, you CAN cut out either channel,
you CAN combine each together without hurting your walkman in the
slightest, AND you can vary the output to be useful with your amp or even
small speakers/headphones. You could also add a very simple "monitoring"
circuit. But, it's up to you.
Hope this helps at least somewhat...
CJ
