Hello to all,
Can anyone help me with the following problem?
I have two X10 MS14A motion sensors at back and front of property and I have this device which connects to the Parallel Port of a PC and is controlled by a Qbasic program.
The QB pgm. monitors 8 inputs (all normally a logic 1) and the device works as expected when a logic 0 test signal is applied.
Does anyone know of an RF Receiver/decoder Circuit that could detect the signals from the MS14A and trigger a small rely which would apply a logic 0 to the input, thus causing
the PC to give it's heads up for that zone.
I'm completely at a loss on this one, any help will be greatly appreciated.
Thanks for taking the time.
Lyle
Can anyone help me with the following problem?
I have two X10 MS14A motion sensors at back and front of property and I have this device which connects to the Parallel Port of a PC and is controlled by a Qbasic program.
The QB pgm. monitors 8 inputs (all normally a logic 1) and the device works as expected when a logic 0 test signal is applied.
Does anyone know of an RF Receiver/decoder Circuit that could detect the signals from the MS14A and trigger a small rely which would apply a logic 0 to the input, thus causing
the PC to give it's heads up for that zone.
I'm completely at a loss on this one, any help will be greatly appreciated.
Thanks for taking the time.
Lyle