P
[email protected]
- Jan 1, 1970
- 0
Hi Community
I'm using Microwave Office 2002.
I have a multi-layer structure.
Until now - for defining a metalization-layer - I always used a
dummy-layer having a thickness of nearly 0 with characteristics of air.
Is this ok like this - or are there any trade-offs?
....I was not sure wether metalization layers are put on top or at the
bottom of a defined layer...
Pascal
I'm using Microwave Office 2002.
I have a multi-layer structure.
Until now - for defining a metalization-layer - I always used a
dummy-layer having a thickness of nearly 0 with characteristics of air.
Is this ok like this - or are there any trade-offs?
....I was not sure wether metalization layers are put on top or at the
bottom of a defined layer...
Pascal