Maker Pro
Maker Pro

my french 1 h/p single phase motor only runs if I pull the belt bit stops under load.

daved

Sep 8, 2021
5
Joined
Sep 8, 2021
Messages
5
Screenshot 2021-09-07 at 6.04.26 PM.png Screenshot 2021-09-07 at 6.04.26 PM.png Screenshot 2021-09-07 at 6.04.26 PM.png Screenshot 2021-09-07 at 6.04.26 PM.png
 

Attachments

  • Screenshot 2021-09-07 at 6.04.26 PM.png
    Screenshot 2021-09-07 at 6.04.26 PM.png
    809.9 KB · Views: 4
  • Screenshot 2021-09-07 at 6.04.26 PM.png
    Screenshot 2021-09-07 at 6.04.26 PM.png
    809.9 KB · Views: 2

Bluejets

Oct 5, 2014
5,856
Joined
Oct 5, 2014
Messages
5,856
In place of providing a number of pics of the same view, how about one or two of a panned out view.
Is the motor as built or have you dismantled it?
 

Minder

Apr 24, 2015
3,268
Joined
Apr 24, 2015
Messages
3,268
You require a replacement start or start-run capacitor.
 

daved

Sep 8, 2021
5
Joined
Sep 8, 2021
Messages
5
The motor is as built. \l have trouble uploading pictures, when the motor runs after pulling the belt it gets very hot I have to switch it off. I wondered if the connections or the capacitor are ok.
 

daved

Sep 8, 2021
5
Joined
Sep 8, 2021
Messages
5
The motor is as built. \l have trouble uploading pictures, when the motor runs after pulling the belt it gets very hot I have to switch it off. I wondered if the connections or the capacitor are ok.
 

Bluejets

Oct 5, 2014
5,856
Joined
Oct 5, 2014
Messages
5,856
Sounds a lot like the start winding is cooked.
Not really a diagnosis job for the inexperienced or those who lack the required test equipment.
 
Top