Maker Pro
Maker Pro

My OPA695 amplifier's voltage

letters109

Mar 10, 2017
4
Joined
Mar 10, 2017
Messages
4
Good afternoon~thanks for taking time to read my question,I hope I came the right froum. Well,time is money so let's enter into the subject directly.My trouble is about "The voltage about OPA695 amplifier".(this is OPA695 I used)Let me describe my problems clearly while you can review my circuit.

Last days,I have printed a board after I made a circuit by using simulation software. However, The voltage which have tagged in the picture is different from the simulate value when I texted the board. In fact,the voltage of R9 two sides in the board just show 0.5V, and R8 shows 4.6v. I can’t understand why occurs such a question? I have review carefully the PCB board,there aren’t any wrong. Can you help me solve it?

Your advice will be appreciated! I'll wait you reply in the forum.Thanks a lot!
wishes~

3.9.2.png
 

Harald Kapp

Moderator
Moderator
Nov 17, 2011
13,700
Joined
Nov 17, 2011
Messages
13,700
Make sure the pinout of the opamp is correct in your layout and the opamp is inserted in teh correct direction.
The datasheet shows the top view.
 

Audioguru

Sep 24, 2016
3,656
Joined
Sep 24, 2016
Messages
3,656
R8 and R9 are connected together on the schematic but since you measure different voltages on them then they are not connected together in your circuit.
 
Top