I have a small Solid State Tesla Coil I'm working on I'm getting an output on my HV side but it's not what I'm looking for, very little break out at an input of 18v pulling between 2A and 6A. Anything higher than that and it's cooking up my Mosfets this is before the paralleling of the Mosfets... The set up in the picture is roughly my current setup with 2 like Fets in parellel.. I'm running 18v into the dual Fets and there still getting very hot, running as if it was still only 1 Fet. Affraid to go any higher on the inputs because I sure don't want to be going through twice as many Fets any suggestions or ideas to help with a higher input on my primary!!! D
Thank You
P.s. High frequency set up!!