Maker Pro
Maker Pro

need help on VGA

rambo99

Apr 24, 2011
63
Joined
Apr 24, 2011
Messages
63
I have a display board for homemade computer I need help on the connection to a VGA monitor there are pin 1,2,3, which are QVSYNC, QHSYNC, XSCL would I need to connect to the VGA is there any other connection pin for the VGA to work I have a picture on the connection
 

Attachments

  • CAM00013.jpg
    CAM00013.jpg
    110.1 KB · Views: 94
  • CAM00014.jpg
    CAM00014.jpg
    119.9 KB · Views: 73
  • CAM00021.jpg
    CAM00021.jpg
    182.5 KB · Views: 82

Martaine2005

May 12, 2015
4,960
Joined
May 12, 2015
Messages
4,960
Hi rambo99,
I think you would be better to work out what signals the vga monitor requires first.
And then see what signals you have.
I don't really know what you mean by a display board for home made computer.
This Wiki has the full pin out for VGA.

Martin
 

rambo99

Apr 24, 2011
63
Joined
Apr 24, 2011
Messages
63
this board can connect to video out and LCD out I what to no can I connect to VGA as the pin have the same as VGA the maximite computer has the same connection the signal is not what I am asking it should work fine
 

rambo99

Apr 24, 2011
63
Joined
Apr 24, 2011
Messages
63
the picture i post say video out lcd out yes please check the picture
 

Martaine2005

May 12, 2015
4,960
Joined
May 12, 2015
Messages
4,960
It looks like you will need a GND connection and the BAS connection for analog video too.

But if your board has the same connector, a VGA, I can only assume that's what it is for.
 
Top