Maker Pro
Maker Pro

Need help to identify component

MartDJ

Nov 17, 2016
2
Joined
Nov 17, 2016
Messages
2
Hi all

I am currently trying to find a replacement for a component in what I think is a wireless module.
However, I have a hard time finding the name for it.

The component I need some help with is the plastic one in the pictures. It also have a screw in it, so I guess it might be for adjusting frequency?

20161117_092249.jpg 20161117_092301.jpg
 

MartDJ

Nov 17, 2016
2
Joined
Nov 17, 2016
Messages
2
Thank you :)

@davenn To be brutally honest, I didn't know what to write. I just wanted to know what it was, as I'm doing a project where I am trying to figure out the function of each component.
 

davenn

Moderator
Sep 5, 2009
14,254
Joined
Sep 5, 2009
Messages
14,254
Thank you :)

@davenn To be brutally honest, I didn't know what to write. I just wanted to know what it was, as I'm doing a project where I am trying to figure out the function of each component.

ahhhh OK :)
I assume there must be some other components on the other side ?
 

tedstruk

Jan 7, 2012
476
Joined
Jan 7, 2012
Messages
476
looks like some kind of plastic thingy with two rings and an adjuster as to which ring gets the most signal. I would call it a freq shunt, or a signal rectifier. Hows my guessing?
 
Last edited by a moderator:

tedstruk

Jan 7, 2012
476
Joined
Jan 7, 2012
Messages
476
Wow... a coil on the board... I was only lookin at the plastic thingy!!
 

cjdelphi

Oct 26, 2011
1,166
Joined
Oct 26, 2011
Messages
1,166
Looks like a tuning circuit part of a tank circuit? Radio something
 
Top