Hi all !
I was hoping to get some advice here. I have a leveno ultrasonic cleaner. It has a heater and LED display. I bought this thing from a local online auction (mistake). Anyways its a brand new unit. I know its not the best out there but I've always wanted one. I went to use it the other day. Put water in it, alittle bit of cleaning solution. Set the temp, and the timer. I turned it on. It worked great for about 2 minutes, then the buzzing stopped. The timer also stopped counting down. I pressed the start button again and it ran for about 5 seconds and stopped again. That's what it does. Stops the cleaning after about 2 seconds. The LED display stays on. I took it apart and all the fuses are good. I looked closely at each part on the circuit board and everything looks fine. There is a circuit board where the electronic display attaches but I did not take that one off to look at it. I'm not an electronic repair person so I'm baffled at why this thing is shutting off. I inspected the round things that produce the ultrasonic waves and they seem to be securely attached to the tub. Does anyone have any ideas on why this might be happening?? Also any idea how much it might cost me to have this unit looked at by an electronic repairman?
Thanks for any help!
I was hoping to get some advice here. I have a leveno ultrasonic cleaner. It has a heater and LED display. I bought this thing from a local online auction (mistake). Anyways its a brand new unit. I know its not the best out there but I've always wanted one. I went to use it the other day. Put water in it, alittle bit of cleaning solution. Set the temp, and the timer. I turned it on. It worked great for about 2 minutes, then the buzzing stopped. The timer also stopped counting down. I pressed the start button again and it ran for about 5 seconds and stopped again. That's what it does. Stops the cleaning after about 2 seconds. The LED display stays on. I took it apart and all the fuses are good. I looked closely at each part on the circuit board and everything looks fine. There is a circuit board where the electronic display attaches but I did not take that one off to look at it. I'm not an electronic repair person so I'm baffled at why this thing is shutting off. I inspected the round things that produce the ultrasonic waves and they seem to be securely attached to the tub. Does anyone have any ideas on why this might be happening?? Also any idea how much it might cost me to have this unit looked at by an electronic repairman?
Thanks for any help!
Last edited: