Maker Pro
Maker Pro

Norcent 42" Plasma TV

C

Chris F.

Jan 1, 1970
0
Someone recently brought in a Norcent PT4235 plasma TV. It had apparently
"just quit". When I plug it in, the relays click a couple of times like it's
trying to start, and a bit of static flashes on the screen, but that's it.
I looked under the back cover and didn't see any bulged or leaking caps,
nor did I find any obvious shorts in the many high-wattage transistors.
Before I go any further with this, I'd like to know if there are any known
issues that someone could point me to. This set has a massive number of
power supplies in it, and I really don't want to waste several hours on
something that may not be fixable in the first place. This is a very cheap
brand of set (retailed for just $700 new), so I doubt it's worth spending
much time on.
Thanks for any advice.
 
M

Mark Zacharias

Jan 1, 1970
0
Chris F. said:
Someone recently brought in a Norcent PT4235 plasma TV. It had apparently
"just quit". When I plug it in, the relays click a couple of times like
it's trying to start, and a bit of static flashes on the screen, but
that's it.
I looked under the back cover and didn't see any bulged or leaking caps,
nor did I find any obvious shorts in the many high-wattage transistors.
Before I go any further with this, I'd like to know if there are any known
issues that someone could point me to. This set has a massive number of
power supplies in it, and I really don't want to waste several hours on
something that may not be fixable in the first place. This is a very cheap
brand of set (retailed for just $700 new), so I doubt it's worth spending
much time on.
Thanks for any advice.

It's a slim shot, but you might try (when powered down) measuring resistance
from the output side of all voltage regulators and rectifiers looking for a
short to ground. (Often the rectifiers are TO-220 packages).
Saved my ass once recently. A Samsung plasma with power supply issues - and
the board no longer available from Samsung. Robbed a TO-220 rectifier of the
same type off a scrap board.

Mark Z.
 
Someone recently brought in a Norcent PT4235 plasma TV. It had apparently
"just quit". When I plug it in, the relays click a couple of times like it's
trying to start, and a bit of static flashes on the screen, but that's it.
I looked under the back cover and didn't see any bulged or leaking caps,
nor did I find any obvious shorts in the many high-wattage transistors.
Before I go any further with this, I'd like to know if there are any known
issues that someone could point me to. This set has a massive number of
power supplies in it, and I really don't want to waste several hours on
something that may not be fixable in the first place. This is a very cheap
brand of set (retailed for just $700 new), so I doubt it's worth spending
much time on.
Thanks for any advice.
A common cause of this problem is a shorted sustain card. This
appears to use an LG panel. One troubleshooting method on these
panels is to unplug the TV, disconnect the cable linking the power
supply to a sustain card, then plug the TV in again and see if the
power supply turns on. If that didn't help,disconnect the next
sustain card.

PlainBill
 

Similar threads

D
Replies
1
Views
1K
Ken G.
K
D
Replies
2
Views
1K
D
B
Replies
0
Views
2K
Brett
B
B
Replies
4
Views
2K
Brett
B
Top