Maker Pro
Maker Pro

Orcad Layout 10.3 Free Via Issue

M

Matt

Jan 1, 1970
0
Hello,

I am trying to attach a copper area to my ground plane using VIAs. I
lay several vias out and make sure their net is set to GND as well. I
get a few down and they are all attached to the GND net then for some
reason, my layout window minimizes and all the vias I had placed are
no longer attached to any net. I can't seem to re attach the vias to
the GND plane. Anyone else run into this issue?

Thanks,
Matt
 
M

Marra

Jan 1, 1970
0
Hello,

I am trying to attach a copper area to my ground plane using VIAs. I
lay several vias out and make sure their net is set to GND as well. I
get a few down and they are all attached to the GND net then for some
reason, my layout window minimizes and all the vias I had placed are
no longer attached to any net. I can't seem to re attach the vias to
the GND plane. Anyone else run into this issue?

Thanks,
Matt

Should have bought PCBCAD21 off ebay.
That automatically creates powerplanes on each layer and connects them
to the desired net.

www.ckp-railways.talktalk.net/pcbcad21.htm
 
Top