Maker Pro
Maker Pro

panasonic tv, enter service menu?

I

I v e k y

Jan 1, 1970
0
i found some hints on net which mention to go into setup and select 'cable'
but there is no cable in it? :)
i need to change 'trapez' just a bit... here is what is circulating around
on net
----
First, select the SET-UP icon and select CABLE mode.
Then, select the TIMER icon and set the SLEEP timer for 30 minutes.
Next, press the ACTION button twice to get out of the menus.
Now, change to channel 124.
Then, adjust the volume to minimum (0).
 
A

Art

Jan 1, 1970
0
Be advised, if you flack the set as a result of playing with the service
menu be sure to tell the servicer company that you eventually take the set
to. That way the tech won't waste his time looking for a "normal" failure
rather than something customer induced. Do not change any paremeters without
first writing down the values, address, and page info. That way you may have
a chance to reset it to the previous (factory) setting.
 
I

I v e k y

Jan 1, 1970
0
Art said:
Be advised, if you flack the set as a result of playing with the
service menu be sure to tell the servicer company that you eventually
take the set to. That way the tech won't waste his time looking for a
"normal" failure rather than something customer induced. Do not
change any paremeters without first writing down the values, address,
and page info. That way you may have a chance to reset it to the
previous (factory) setting. "I v e k y" <i v e k y @ e m a i l . h i
n e t . h r> wrote in message news:[email protected]...


i still wait way how to enter into serviceman, and this words from you are
welcome but also not needed cos i am not kid, and this is my x-th tv set,
before 20 years i needed to open them to adjust picture, and lately
(samsung, sony) i could adjust it without openig it :)
do you know how to enter into serviceman on new panasonics for european
market?
 
S

Sofie

Jan 1, 1970
0
I v e k y:
Heed the advice of Art's reply post to you.....
.....You may not be a kid...... but I have seen intelligent adults screw up
the service parameters so badly that anything short of a full factory
alignment and possibly replacement EPROM chips would not make the set work
properly again.
Be very careful.
 
I

I v e k y

Jan 1, 1970
0
hey sofie, you wrote again 7 lines and repeated what was said many many
times, but you haven't give rigt answer, if you don't know how to enter into
it, there is no need to reply
btw. with tv set i got german, french, italian, greek manual.... ONLY in
italian manual there is 4 pages more then in others (they lack it) with
explanations of settings in service menu, but there is no explanation how to
enter into it :)
for others: if you don't know right answer, i DON'T need again advice 'you
can screw your settings', you waste your time writing such reply :)
 
A

Art

Jan 1, 1970
0
Entry sequence is same internationally. while pressing the volume down
button a chk logo should appear on the screen in upper left area. Now you
may select an active channel or video source if you would like. Next press
the Power button on the remote, not on the tele. This should bring you
either to a full page of selections that you may access and adjust or you
may just see a separate line of code, again in the upper left quadrant of
the screen. The buttons on the remote may have multiple functions.<
It is totally irrelevant if you are an adolescent or over fifty, many have
tried and many have failed. Personally, @ tis point I wold suggest having a
professional have a go at the set and folow their suggestions. Cheers &
Happy Hanukkah
 
Top