PCB fab house that can do large boards

[Kevin C]

I am having some trouble locating a PCB fabricator that is capable of
fabricating the size board that I need. I need 28" x 25" board. Do any
of you know of any reputable fab houses that can do this?

Thanks
Kevin

 

[Joerg]

I am having some trouble locating a PCB fabricator that is capable of
fabricating the size board that I need. I need 28" x 25" board. Do any
of you know of any reputable fab houses that can do this?

It's in Europe and they did a huge backplane and many large boards for
us, not cheap but top notch in quality:
http://www.andus.de/

It's been >10 years. IIRC their English was ok (but I also speak German).

 

[Robert]

I am having some trouble locating a PCB fabricator that is capable of
fabricating the size board that I need. I need 28" x 25" board. Do any of
you know of any reputable fab houses that can do this?

Thanks
Kevin

I'll ask tomorrow when I'm at work.

Robert

 

[Ian]

I am having some trouble locating a PCB fabricator that is capable of
fabricating the size board that I need. I need 28" x 25" board. Do any of
you know of any reputable fab houses that can do this?

Thanks
Kevin

I'm pretty sure Multek can do that size http://www.multek.com/
They have plants in Germany and China.

Regards
Ian

 

[Robert]

I'll ask tomorrow when I'm at work.

Robert

Checked with a PCB list I'm on at work and got two recommendations.

*********************
Try Titan Circuits. Ask for Maria. 510-824-1222
Tell her I sent you.

*********************
Flashline Electronics - Tom Hanighen, good prices - great service.
916-983-8240


Robert

 

[Ben Jackson]

I am having some trouble locating a PCB fabricator that is capable of
fabricating the size board that I need. I need 28" x 25" board. Do any
of you know of any reputable fab houses that can do this?

Even if you get the PCB made, you will probably have trouble getting
it stuffed. We had a board at work that was 16" square with a protrusion
to bring a port flush with the sheetmetal. The extra expense of building
it led to a redesign to remove the protrusion and move the sheet metal.

Unless you're making a kit. ;-)