Hi, I am new to this forum and I need some help.
I am working on a science fair project and I am making a PCB induction charger. I have etched my coils onto my copper-clad board and started some testing using a 22V input. No power transfer occurred between the two boards. I tried adding a 470ohm resistor to create a load but that did not work. I do not know what I need to do to be able to transfer the energy. Attached is a picture of my setup.
I am working on a science fair project and I am making a PCB induction charger. I have etched my coils onto my copper-clad board and started some testing using a 22V input. No power transfer occurred between the two boards. I tried adding a 470ohm resistor to create a load but that did not work. I do not know what I need to do to be able to transfer the energy. Attached is a picture of my setup.